THE FULL FIRST-RESPONSE GUIDE
What to do about water in a crawl space, in order.
Stay out of the crawl space.
Look from the access opening only. Standing water can be in contact with wiring, a junction box or an appliance. The space is tight and hard to leave quickly, and the water may be contaminated. The U.S. Department of Energy’s Building America guidance is direct: if a section has a significant amount of standing water, do not go into that area.
Rule out a pressurized leak.
Turn off every fixture and appliance that uses water, then listen at the access. Hissing, spraying or steady running means a supply pipe is leaking. Close the main water valve if you can reach it without entering the crawl space. Your water meter can also show flow when nothing is in use.
Check for a drain or sewer leak.
A sewage odor, gray water or toilet paper on the ground means a drain line under the house is leaking or has come apart. Stop flushing and draining water as far as you can, and call a plumber. Treat everything the water touched as contaminated.
Consider rain and groundwater.
If the water appeared during or after heavy rain and there is no sound of running water, it has probably come through or under the foundation. From outside, check that downspouts are connected and drain away from the house. Groundwater cannot be shut off. It has to be drained or pumped out, and the cause corrected.
Protect the house above.
If the furnace or ducts are under the house and may be wet, switch the system off at the thermostat until it has been checked. Note any soft, cupped or stained flooring in the rooms above. Keep the access cover in place so children and pets stay out.
Arrange water removal and a moisture assessment.
Call a plumber for a pipe or drain leak, and Superior for the water and the structure. After the water is out, the framing, subfloor and insulation need to be checked with moisture meters to help determine which materials are affected. With sewage or groundwater, readings guide the drying. They do not establish that contamination has been removed.
IDENTIFY FROM THE ACCESS
Where crawl space water usually comes from.
Describe what you can see, hear and smell from the access. Do not go in to confirm it.
| Possible source | What you may notice | What to do |
|---|---|---|
| Supply pipe leak | Clear water, the sound of spraying or running, or a wet area below a bathroom or kitchen. It does not depend on the weather. | Close the main water valve and call a plumber. A pipe that froze may have split in more than one place. |
| Drain or sewer line leak | Sewage odor, gray or dark water, paper or waste, or wet ground below a toilet or tub drain. | Limit water use and call a plumber. Keep everyone out. This is sewage. |
| Groundwater or surface water | Water appears with heavy rain, often across a low area or along the foundation wall, and drops slowly afterward. | Check gutters and downspouts from outside. A drainage contractor needs to find how the water gets in. Pumping alone will not stop it returning. |
| Failed sump pump or blocked drain | A sump pit under the house is full and the pump is silent, or a low-point drain is under water. | Do not reach into the pit. A plumber or drainage contractor can test the pump, its power supply and the discharge line. |
A PIPE CAN BE SHUT OFF · GROUNDWATER CANNOT
What you can stop from outside the crawl space.
Everything here is done from outside the crawl space. If the only water shutoff is inside it, call your water provider or a plumber.
Supply leak: close the main water valve.
Look for the house shutoff in the garage, a utility closet or the basement, or on an outside wall. A lever closes across the pipe. A round handle closes clockwise. If the valve is inside the crawl space, do not go in for it. Ask your water provider or a plumber to turn the water off at the street.
Drain leak: stop sending water down.
Avoid flushing, showers, laundry and the dishwasher until a plumber has found the break. Closing the water supply does not remove what is already in the drain line.
Rainwater: move it away from the foundation.
From outside, and only in safe conditions, reattach or extend downspouts, clear blocked gutters and move anything that directs water toward the foundation vents or the access.
Leave pumps and wiring alone.
Do not plug in, unplug or reset a sump pump or any other equipment under the house while the ground is wet. Do not run an extension cord into the crawl space.
Open · Along the pipe
Closed · Across the pipe
A round multi-turn handle is different: gently turn it clockwise until snug. Never force a stuck valve.
AFTER THE SOURCE IS CONTROLLED
What you can do yourself, and why it is limited.
There is very little safe do-it-yourself cleanup in a flooded crawl space. Entry, pumping, removing wet insulation and cleaning a contaminated ground cover are jobs for people with the right equipment and protection. Your part is outside the crawl space and in the rooms above it.
Fix what you can reach from outside.
Clear gutters, connect downspouts and make sure they discharge away from the house. Clear leaves and soil from foundation vents and the access well.
Keep engines and fuel away.
Never run a gasoline pump, generator or heater in a crawl space or near its vents or access. CPSC warns that carbon monoxide from a portable generator can kill in minutes, and that one must never run in an enclosed space such as a crawl space.
Do not add heat, fans or lights.
Do not put space heaters, household fans or plug-in work lights into a wet crawl space. They are an electrical hazard there, and they do little to dry wood framing.
Watch the rooms above.
Check floors for new cupping, soft spots or odor, and look at the base of the walls over the wet area. Photograph changes and note the date.
Keep the access closed.
Put the hatch or cover back so nobody enters. Tell everyone in the household that the space is off limits until it has been cleared.
WHERE THE DAMAGE CAN SPREAD
What is wet under the house affects the rooms above.
A crawl space is part of the building. Water that stays there raises the moisture in the framing, the insulation and the floor you walk on.
Moisture meters, not a look from the hatch
Wood under the house can look and feel dry while holding too much moisture. Superior uses moisture meters to help determine which joists, beams and subfloor areas are affected and how far water traveled. If the water was sewage or groundwater, dry readings do not establish that contamination has been removed.
Subfloor and flooring above
Moisture from below moves into the subfloor. Cupped hardwood, loose tiles, soft spots or a musty smell in the rooms above can be the first sign of water in the crawl space.
Insulation, ducts and the ground cover
Wet floor insulation sags and holds water against the wood. Ducts can take in water or draw damp air into the house. Water can also sit on top of the plastic ground cover, where it cannot drain away.
Furnace, water heater and wiring
Equipment and wiring in the crawl space that got wet need to be checked by a qualified technician before use. Tell us if the furnace or water heater is under the house.
HOW SUPERIOR HELPS
Get the water out, then dry the structure above it.
Tell Superior what you can see from the access, whether it has been raining and whether you smell sewage. The source decides the cleanup and who else needs to be called.
Assess before entry
Check the access, electrical hazards and the type of water before anyone goes in. Inspect framing, subfloor and insulation, and use moisture meters to help map the affected areas, including the floor above.
Remove water and wet materials
Pump out standing water. Remove wet insulation, debris and contaminated ground cover that cannot be cleaned or dried, and clean affected surfaces as the water type requires.
Dry the framing and check it
Set drying equipment for the crawl space and track the wood’s moisture with follow-up readings. Explain what plumbing, drainage or ground-cover work others still need to complete.
KEEP THE FACTS TOGETHER
Record what is under the house.
Because nobody should go in, your record is made from the access and from the rooms above. Ask your insurer what it needs. Policies often treat groundwater and long-term leaks differently from a sudden pipe failure.
- When the water was found, the recent weather and whether it has been there before.
- Photos from the access showing the water against a pier or the foundation wall, the ground cover and the insulation.
- What you heard or smelled, and whether the water meter showed flow with every fixture off.
- Photos of the floors and walls in the rooms above the wet area.
- The plumber’s or drainage contractor’s findings, the water removal and cleanup scope, moisture-check records for the framing and subfloor, and drying records.
REPAIR · CLEAN · CONFIRM DRYING
Before the crawl space is closed up again.
- Confirm the source is corrected: the pipe or drain is repaired, or the drainage or sump problem has been addressed.
- Have wiring, the furnace, ducts and any water heater that got wet checked by qualified technicians before use.
- Ask for the moisture-meter findings for the joists, beams and subfloor. Confirm that the wood meets the restoration drying criteria before new insulation or ground cover is installed.
- If the water was sewage or groundwater, confirm what was removed and how the remaining surfaces were cleaned. Dry readings do not establish that contamination has been removed.
- Have the space looked at again after the next period of heavy rain.
AFTER THE IMMEDIATE PROBLEM
Keep water out of the crawl space.
- Keep gutters clean and downspouts discharging away from the foundation, and keep the soil sloped away from the house.
- Keep a continuous ground cover of heavy plastic sheeting over the soil, with overlapped seams, and repair it when it is torn or displaced.
- If water collects regularly, ask a drainage contractor about perimeter drainage and a sump pump with a sealed lid. A pump alone may not solve water coming in.
- Insulate supply pipes under the house, and close gaps that let freezing wind reach them.
- Look in from the access with a flashlight a few times a year, after heavy rain and after any plumbing work.
QUESTIONS BEFORE YOU CALL
A few things you may be wondering.
Is some water in a crawl space normal?
No. Soil can be damp in wet weather, but standing water, wet insulation or water on top of the ground cover means something needs attention: a leak, a drainage problem or a failed pump.
Will it dry out on its own?
Rarely well enough. A crawl space has little air movement, and wet insulation and wood can stay damp for a long time. Wood that stays wet can grow mold and decay. The source has to be stopped and the wood’s moisture checked.
Can I put a pump down there myself?
Not by going in. Do not enter standing water or run cords through it, and never run a gasoline pump or generator in or near a crawl space. Pumping also does not fix the source. If groundwater is the cause, the water will return.
Who fixes the cause?
A plumber repairs supply and drain pipes. Gutter, grading, drainage and sump work belongs to a drainage or foundation contractor. Superior removes the water, cleans up, dries the structure and tells you what we found.
Sources and further detail
General safety and equipment references checked November 17, 2026. Use the instructions for your exact appliance or valve when they differ.
- U.S. Department of Energy Building America: looking at a crawl space for moisture problems ↗
- U.S. Department of Energy Building America: water management for an existing crawl space floor ↗
- OSHA: confined spaces in residential construction, including crawl spaces ↗
- CPSC: generator and flood-damaged equipment safety ↗
- CDC: what floodwater can contain ↗
- City of Vancouver: using the water meter to detect a leak ↗
- EPA: using moisture meters to locate wet materials and monitor drying ↗

